Appliance Spares
Quick answer: If your Haier fridge is warm but the freezer is still cold, the compressor runs, and you hear a buzzing or clicking from the freezer, the evaporator fan motor has failed. This DC12V fan pushes cold air from the freezer coil up into the fridge — when it dies, the fridge warms while the freezer stays icy. It’s a 30–45 minute DIY swap behind the rear freezer panel. We stock Haier fan motors (HR05X01365, HR05X00410 and more) with same-day Sydney dispatch.
The part that fixes this
- Haier Fridge Freezer FAN MOTOR HRF454TW, HRF360TW, HRF220TW
- Haier Fridge Freezer FAN MOTOR HRF454TS, HRF360TS, HRF220TS
- Haier Fridge Fan Motor & Blade Assy Suits HRB227W, HRB227S, HRF360TS
Not sure it is the same on your machine? See every part listed by Haier model number.
Last updated September 2026
Find your exact part with the Oz Part Finder
What the evaporator fan motor actually does
The evaporator fan motor is the small electric fan that sits behind the rear panel of your Haier freezer, right next to the cold cooling coil (the evaporator). Its only job is to blow chilled air off that coil and circulate it — up into the fresh-food compartment through a duct, and around the freezer itself. On almost every modern Haier (HRF and HRB series), this is a DC12V brushless fan motor controlled by the main board, not a 240V mains motor. The compressor and coil make the cold; the fan is what delivers it. That distinction is the key to diagnosis: if the fan stops, the freezer still gets cold by direct contact with the coil, but the fridge compartment — which relies entirely on fan-forced air — slowly climbs to room-ish temperatures even though the compressor keeps running. No fan, no airflow, warm fridge.
Symptom check — is it really the fan motor?
Match your symptoms to the table before pulling anything apart. The classic evaporator-fan signature is a warm fridge with a working freezer.
| What you’re seeing/hearing | Most likely cause | Is it the fan motor? |
|---|---|---|
| Fridge warm, freezer cold, compressor runs | No airflow to fridge | Yes — failed fan motor |
| Loud buzzing / humming from freezer back wall | Worn fan bearing struggling | Yes — failing fan motor |
| Clicking or ticking from freezer | Fan blade hitting ice or a seized motor | Likely — check for ice first |
| Both fridge AND freezer warm, compressor runs | Gas/sealed system or compressor | No — call a technician |
| Both warm, compressor silent | Compressor, start relay or board | No |
| Noise only when door first opens | Fan kicks back on (normal) | No |
The give-away test: open the freezer and press the door switch in by hand. The fan should spin and you should feel/hear airflow. If it’s dead silent (or grinding/buzzing) while the compressor hums, the fan motor is your fault.
First, rule out an ice build-up
Before you condemn the motor, check that the fan isn’t simply jammed by frost. A failed defrost system lets ice form over the evaporator coil and around the fan blade — the blade then clicks against the ice or stalls, mimicking a dead motor. Unplug the fridge at the wall, take out the rear freezer panel (a few screws), and look at the coil and fan. If you see a thick wall of white frost encasing the coil or blade, your real fault is the defrost circuit (defrost heater, sensor or timer), not the fan. Clear the ice with a hair dryer on low, dry everything, and if frost returns within a day or two, diagnose defrost next. If the coil is clean and clear of frost but the fan still won’t spin freely by finger, or it spins but buzzes/grinds, the fan motor itself is worn out and needs replacing.
How to access the fan (rear freezer panel)
Accessing a Haier evaporator fan is straightforward on HRF and HRB models. Unplug the fridge at the wall first — never work on it live. Empty the freezer and remove the baskets or drawers so you can reach the back wall. The fan lives behind the rear interior panel of the freezer compartment. Remove the visible screws (usually 4–6, sometimes hidden under small plastic caps or behind the lower drawer rail), then gently ease the panel off — go slowly, as a wiring harness and the defrost sensor are often clipped to it. With the panel off you’ll see the silver evaporator coil and the fan motor mounted in its plastic shroud or bracket. Note how the blade, shroud and wiring plug sit before you disturb anything — a quick phone photo saves grief on reassembly. The motor unclips or unscrews from its bracket, and the wiring connector simply unplugs.
Identify your Haier model and the right motor
Get the right part by reading the model number, not guessing. Your Haier model and serial sticker is on the left-hand wall inside the fridge compartment, near the top, or sometimes on the back of the cabinet. Haier fridge models start with HRF (most upright/bottom-mount fridge-freezers) or HRB (bottom-mount), e.g. HRF454TW, HRB227S, HRF565YHC. Write the full code down. Most Haier evaporator fans are DC12V units sharing a handful of part numbers — HR05X01365 covers a big run of HRF220/360/454 models, while HR05X00410 (a fan-and-blade assembly) suits HRB227 and similar. If your fridge is a side-by-side, the larger HRF516/HRF565 motors apply. Cross-check the part number printed on the old motor against the table below; matching either your model or the old part number gets you the correct fan.
Haier evaporator fan motors we stock
Match your model or the number printed on the old motor. All are DC12V Haier fans (one listed unit is sold under the Hisense brand — noted below — and shares the K-series fridge platform). Always confirm against your model sticker before ordering.
| Part number | Fits (examples) | Link |
|---|---|---|
 HR05X01365 | HRF454TW, HRF360TW, HRF220TW (white) | |
 HR05X01365 | HRF454TS, HRF360TS, HRF220TS (steel) | |
 HR05X00410 | HRB227W, HRB227S, HRF360TS (fan + blade assy) | |
 (62181-A) | HRF565YHC, HRF516YS | |
 H0060840534N | HRF422TW1, HRF502TS1 | |
 K1960962 (Hisense-branded) | HR6TFF459, HR6CDFF670S/B, HRTF326 |
Haier and Hisense share refrigeration platforms in Australia, so the K1960962 fan is listed honestly under its Hisense branding — it suits HR6-series fridges, not the HRF/HRB Haier line. Can’t match it yourself? Run your model through the Oz Part Finder.
Fitting the new motor and what it costs
With the old motor out, transfer the fan blade if your replacement doesn’t include one (the HR05X00410 listing comes as a complete fan-and-blade assembly, which saves the swap). Clip or screw the new DC12V motor into the same bracket, route the wiring the way you photographed it, plug in the connector, and refit the rear panel and any drawers. Don’t pinch the harness or the defrost sensor behind the panel. Plug the fridge back in, press the freezer door switch, and confirm the fan spins quietly with good airflow. Give it a few hours to pull the fridge back down to temperature. Cost: a genuine Haier evaporator fan motor typically runs AUD $45–$95 depending on model, versus $250–$400+ for a technician call-out and part. A like-for-like fan swap is one of the cheapest fridge repairs going, and it keeps an otherwise healthy fridge running for years rather than spending hundreds replacing the whole appliance over a $50 part.
Safety note
A fridge evaporator fan motor is a low-voltage DC12V component, but you still unplug the fridge at the wall before you start — the mains supply, compressor and defrost heater behind the same panel are 240V and dangerous live. Work with dry hands, don’t poke at the compressor wiring or the sealed gas system, and never cut into any refrigerant lines (that’s licensed-technician territory in Australia). If you’re at all unsure about the wiring or you find a sealed-system fault, stop and use a licensed appliance technician working to AS/NZS standards.
Frequently Asked Questions
Why is my Haier fridge warm but the freezer is still cold?
That’s the textbook evaporator fan motor failure. The freezer stays cold because it sits right next to the cooling coil, but the fridge compartment relies on the fan to push cold air up to it. No fan, no airflow, so the fridge warms while the compressor keeps running and the freezer stays icy.
What does a failing Haier fridge fan motor sound like?
A worn fan motor bearing makes a loud buzzing, humming or rattling from the back wall of the freezer, often louder when the door is open and the fan is running. A clicking or ticking usually means the blade is striking ice or the motor has seized. Both point to the fan — but rule out frost build-up first.
Are Haier fridge fans 240V or low voltage?
Almost all modern Haier fridge evaporator fans (HRF and HRB series) are DC12V brushless motors run from the main control board, not 240V mains motors. You still unplug the fridge at the wall before working, because mains components share the space behind the rear panel.
Where is the model number on a Haier fridge?
Look on the left-hand interior wall of the fridge compartment near the top for the rating/serial sticker, or on the back of the cabinet. Haier fridge models start with HRF or HRB (e.g. HRF454TW, HRB227S). Use the full code to match the correct fan.
How much does a Haier evaporator fan motor cost in Australia?
A genuine replacement Haier fan motor is usually AUD $45–$95 depending on the model. That compares with $250–$400 or more for a technician to attend and fit one, so it’s one of the cheapest fridge repairs you can do yourself.
My fridge and freezer are BOTH warm — is it the fan?
Probably not. If both compartments are warm and the compressor is running, the fault is more likely the sealed system or gas charge. If both are warm and the compressor is silent, suspect the compressor, start relay or main board. A failed evaporator fan typically leaves the freezer cold.
Will a Hisense fan motor fit my Haier fridge?
Only if your appliance is actually a Hisense HR6-series fridge. The K1960962 fan we list is Hisense-branded for models like HR6TFF459 and HR6CDFF670 — it is not a substitute for the HRF/HRB Haier fans. Always match the part to your own model and the number on the old motor.
Frequently asked questions
Why is my Haier fridge not cold but the freezer still works?
That is the textbook evaporator fan motor failure. The freezer sits right next to the cooling coil so it stays cold, but the Haier fridge compartment relies entirely on the fan to push cold air up through a duct — no fan, no airflow, warm fridge.
What does a failing Haier fridge fan motor sound like?
A worn fan motor bearing makes a loud buzzing, humming or rattling from the back wall of the freezer. A clicking or ticking usually means the fan blade is striking ice or the motor has seized. Rule out frost build-up before condemning the Haier fan motor.
How much does a Haier fridge fan motor cost in Australia?
A genuine Haier evaporator fan motor typically runs AUD $45–$95 depending on the model, versus $250–$400 or more for a technician call-out and part. That makes the fan swap one of the cheapest fridge repairs you can do yourself.
Where is the model number on a Haier fridge?
Check the left-hand interior wall of the fridge compartment near the top, or the back of the cabinet. Haier fridge models start with HRF or HRB — for example HRF454TW or HRB227S. Use the full code to match the correct DC12V fan motor.
How long does it take to replace a Haier fridge fan motor?
It is a 30–45 minute DIY swap. Unplug the Haier fridge, empty the freezer, remove the rear panel screws, unclip the old motor and plug in the new one, then allow a few hours for the fridge to pull back down to temperature.
Are Haier fridge fan motors 240V?
Almost all modern Haier evaporator fans in the HRF and HRB series are DC12V brushless motors run from the main control board. You still unplug the fridge at the wall before working, because the compressor and defrost heater behind the same panel are 240V and dangerous live.
Related guides
- Find your exact part with the Oz Part Finder
- Fridge not cold? Evaporator fan motor diagnosis (other brands)
- Fridge defrost heater and sensor replacement (when ice keeps coming back)
Ready to fix it?
Read your Haier model number, match it to the table above, and get the right DC12V fan motor on its way with same-day Sydney dispatch. Not 100% sure which one fits? Find your exact part with the Oz Part Finder and we’ll confirm the correct motor for your HRF or HRB fridge.
