A loud Hisense washing machine is almost always worn drum bearings (a grinding rumble on the spin that gets louder as it speeds up) or a coin or worn drain pump (rattling during the drain). The bearing and lip-seal kit runs about $56–$66 and the drain pump about $40–$70 — both a sm
A loud Haier washing machine usually comes down to one of three things: worn drum bearings on a front loader (a grinding rumble that builds with the spin speed), a coin or worn drain pump (rattling during the drain), or, on a twin-tub, a worn spin-tub seal and bush. The bearing kit is around $55, th
If your Hisense fridge has a freezer that’s still cold but a fridge section that’s gone warm, the most common cause is the electric air damper (Hisense calls it the wind gate) — the motorised flap that lets cold air from the freezer into the fridge. When it sticks shut or its motor fails, the
A Haier fridge that’s icing up and not defrosting — frost packing over the freezer back panel while the fridge slowly warms — has usually lost its defrost heater, defrost sensor, or the thermal fuse that feeds it. The frost-free cycle can’t melt the evaporator coil, so ice builds until i
If your Hisense fridge is building up ice on the back wall of the freezer, frosting over, or the fridge section is slowly going warm, the auto-defrost system has stopped running — usually a failed defrost timer, defrost thermostat/temperature fuse, or defrost sensor. Frost then packs over the
If you own a budget or retailer house-brand appliance — an Aldi Stirling, Esatto, InAlto (Winning Appliances), Technika, Euromaid, Midea, Haier, Hisense, Seiki or similar — the original retailer usually has no spare-parts counter once you’re out of warranty. The good news: these machines
If your Aldi Stirling front loader won’t drain and sits full of water at the end of the cycle, start with the pump filter behind the bottom kick panel — a coin, hair clip or sock jams the pump more often than not, and clearing it is free. If the filter’s clear and the pump just hums or stays s
An Aldi Stirling front loader that’s grown loud and rumbly on the spin — a grinding roar that gets worse as the speed climbs — almost always has worn drum bearings. The fix is a $58.95 bearing and lip-seal kit. It’s the most involved washer repair, but the part is a fraction of a new mac
If your Aldi Stirling front loader fills, washes and drains but won’t spin up — or the drum turns slowly while the motor revs — the drive belt has almost always worn, stretched or slipped off. It’s a $34.95 part and a confident DIYer can fit it in about 30–45 minutes. A snapped or
A loud Samsung washing machine almost always comes down to one of four things: worn drum bearings (a grinding rumble that gets louder as the spin speeds up), tired suspension (banging and knocking as the drum hits the cabinet), a corroded drum spider, or a coin or worn drain pump (rattling during th
Appliance Spares