Electrolux & Westinghouse Parts Australia | Common Issues & Spare Parts

Electrolux & Westinghouse Parts Australia | Common Issues & Spare Parts

Key Takeaways

• Electrolux and Westinghouse are owned by the same company — many parts cross-fit both brands
• Most common fix: door seals on washing machines (part 1320723614) and thermostats on Westinghouse fridges (3890824016)
• Both brands are built to last — parts are available for models up to 20 years old
• $9.95 flat-rate shipping Australia-wide, same-day dispatch on orders before 2pm

Electrolux and Westinghouse are two of the most common appliance brands in Australian homes — and because they share the same parent company, a lot of their parts are interchangeable. That matters when you’re trying to find the right seal or pump: a part listed for an Electrolux might also fit your Westinghouse, and vice versa.

This guide covers the most common problems with both brands, the part numbers you’ll need, and how to work out which part fits your specific model.

Most Common Electrolux & Westinghouse Problems

Electrolux Washing Machine Making a Rumbling Noise

A low rumbling or grinding sound during the spin cycle usually means the drum bearing is failing. It tends to get louder over time and eventually the machine will start to leak from the back as the bearing seal breaks down.

The part to replace is the bearing seal assembly — part 1463211005 fits many Electrolux front loaders. This is a more involved repair than a door seal; you need to split the drum to access the bearing. It’s doable as a DIY job if you’re comfortable with appliance repairs, but worth knowing before you start.

Electrolux Washing Machine Leaking from the Door

Water on the floor in front of your machine almost always means the door seal (boot gasket) has cracked or torn. Check the rubber seal around the drum opening — look for tears, holes, or black mould that’s eaten through the rubber.

Part 1320723614 fits a wide range of Electrolux front loaders. Door seal replacement takes about 30–45 minutes and is one of the more satisfying DIY repairs.

Electrolux Washing Machine Not Draining

If the machine stops mid-cycle with water still in the drum, start by checking the pump filter (the little cap at the bottom front of the machine). It’s the most common cause and takes 5 minutes to clean.

If the filter is clear and the problem persists, the drain pump motor may need replacing. Part 1461770004 is the pump assembly for most Electrolux front loaders.

Westinghouse Fridge Not Keeping Temperature

If your Westinghouse fridge is cycling on and off more than usual, not staying cold, or freezing everything in the fridge section, the thermostat is the first thing to check.

Part 3890824016 is the thermostatic control for most Westinghouse fridge models. Before replacing it, check the door seal is sealing properly (the paper test — close the door on a piece of paper and pull it out; you should feel resistance).

Electrolux or Westinghouse Oven Not Heating Properly

Ovens that heat unevenly or not at all usually have a failed bake element or grill element. You can often see the fault — a cracked or blistered element is clearly broken, while a failed thermostat looks fine but doesn’t regulate temperature correctly.

Part 3871815016 is the oven heating element for a range of Electrolux and Westinghouse oven models. Always switch off power at the wall before working on any oven element.

Popular Electrolux & Westinghouse Part Numbers

Not sure if a part fits your model? Check the sticker inside your door frame or drum opening for your full model number and contact us — we can confirm compatibility before you order.

Do Electrolux and Westinghouse Parts Fit Each Other?

Sometimes yes, sometimes no — and the answer depends on the specific part and model year.

Because Electrolux owns Westinghouse, they share platforms for some appliance lines. In practice, this means:

• Washing machines: Parts often cross-fit within the same model generation. Door seals, pumps, and inlet valves are the most likely to be interchangeable.
• Fridges: Less cross-compatibility here — Westinghouse fridges tend to use their own part numbers, though some thermostat and gasket parts do overlap.
• Ovens: Heating elements frequently cross-fit. Thermostats are more model-specific.

The safest approach: get your full model number (it’s on a sticker inside the door or on the back panel) and check before ordering.

How to Find Your Model Number

Electrolux and Westinghouse model stickers are usually in one of these spots:

• Washing machine: Inside the door frame, on the rubber seal edge, or on the back panel
• Fridge: Inside the fridge on the side wall, usually near the top shelf
• Oven: Inside the oven door frame, or on the back of the appliance

You need both the model number (e.g. EWF1276) and the serial number to confirm compatibility on older models.

Need a part for your Electrolux or Westinghouse? We stock the most common parts and can source older components. Same-day dispatch on orders before 2pm, flat $9.95 shipping Australia-wide.Shop Electrolux & Westinghouse Parts →

Is It Worth Repairing an Older Electrolux or Westinghouse?

Both brands are known for durability — it’s not unusual to find 15-year-old Electrolux washing machines and Westinghouse fridges still going strong in Australian homes. As a general rule:

• If the repair cost is less than half the price of a new appliance, it’s almost always worth fixing
• Door seals, pumps, thermostats, and elements are all reasonable repairs at any age
• Drum bearings and control boards are bigger investments — worth assessing based on the machine’s overall condition
• If the drum is cracked or the compressor has failed, replacement is usually the better call

Frequently Asked Questions

Are Electrolux and Westinghouse the same brand?

They’re separate brands under the same parent company — AB Electrolux, a Swedish manufacturer. In Australia, Westinghouse has been sold as a standalone brand for decades, but it’s manufactured and supported through Electrolux’s supply chain. This is why you’ll find cross-compatible parts between the two brands.

What’s the most common Electrolux washing machine problem in Australia?

Door seal failure and drum bearing wear are the two most frequent issues. Door seals tend to develop mould and then crack after 5–8 years, especially in humid climates. Drum bearings usually start to go at the 7–10 year mark and announce themselves with a growing rumbling noise during spin.

My Westinghouse fridge is freezing food in the fridge section — what’s wrong?

The thermostat is the most likely culprit. When it fails, it can stick in the “on” position, making the fridge run continuously and get too cold. Part 3890824016 is the replacement thermostat for most Westinghouse models. Before replacing it, check the temperature dial hasn’t been accidentally turned up.

Is bearing seal replacement a DIY job on an Electrolux?

It’s technically possible but it’s one of the more involved washing machine repairs — you need to split the drum casing to access the rear bearing. If you’ve done appliance repairs before and you’re comfortable disassembling major components, it’s doable. If it’s your first time inside a washing machine, getting a tradie to do this one is worth it.

Do you have parts for old Electrolux and Westinghouse models?

Yes. Both brands have a reputation for longevity and we stock parts for models going back 15–20 years. For anything we don’t have on the shelf, we can usually source it within 5–7 business days. Give us your full model number via the contact page and we’ll check availability.

What’s the difference between OEM and compatible parts for Electrolux?

OEM (Original Equipment Manufacturer) parts are made by Electrolux or their authorised suppliers and guaranteed to fit. Compatible parts are made by third-party manufacturers to the same specifications — they’re usually cheaper and fit just as well for most components like seals, filters, and belts. For control boards and electronic components, OEM is worth the extra cost.

Get the Right Part for Your Electrolux or Westinghouse

OZ Appliance Spares has been supplying Australian homeowners with genuine and compatible appliance parts since 2009. Sydney warehouse, same-day dispatch, $9.95 flat rate shipping nationwide.Shop All Electrolux & Westinghouse Parts →

Frequently asked questions

Are Electrolux and Westinghouse parts interchangeable?
Sometimes — both brands sit under the same Swedish parent, AB Electrolux, and share platforms for some appliance lines. Washing machine door seals, pumps and inlet valves are the most likely to cross-fit within the same generation; fridges cross over less, while oven heating elements frequently fit both. Always confirm with your full model number.

What causes a rumbling noise in an Electrolux washing machine?
A low rumbling or grinding sound during spin usually means the drum bearing is failing — it gets louder over time and eventually leaks from the back as the bearing seal breaks down. Part 1463211005 is the bearing seal assembly for many Electrolux front loaders, but the drum must be split to fit it.

Why is my Westinghouse fridge freezing food in the fridge section?
The thermostat is the most likely culprit — when it fails it can stick in the on position, making the fridge run continuously and get too cold. Part 3890824016 is the thermostatic control for most Westinghouse fridge models. First check the temperature dial hasn’t simply been turned up by accident.

Do you have parts for old Electrolux and Westinghouse models?
Yes — both brands are known for durability, and Oz Appliance Spares stocks parts for models going back 15-20 years. Anything not on the shelf can usually be sourced within 5-7 business days; send the full model number via the contact page and availability can be checked for you.

How much is shipping on Electrolux and Westinghouse parts in Australia?
Oz Appliance Spares charges $9.95 flat-rate shipping Australia-wide, with same-day dispatch from the Sydney warehouse on orders placed before 2pm. The business has been supplying Australian homeowners with genuine and compatible appliance parts since 2009.

Is it worth repairing an older Electrolux or Westinghouse appliance?
Usually — if the repair costs less than half the price of a new appliance, it’s almost always worth fixing. Door seals, pumps, thermostats and elements are reasonable repairs at any age; drum bearings and control boards are bigger investments, and a cracked drum or failed compressor usually means replacement.

Related guides

• Westinghouse, Simpson & Electrolux washing machine error codes

Disclaimer: this article is general information only and is provided without warranty of any kind. Appliance designs vary between models and production runs — always follow the manufacturer’s instructions, switch off and unplug the appliance before starting any work, and confirm parts against the model number on your appliance’s model sticker. Any repair is undertaken at your own risk and Oz Appliance Spares accepts no liability for injury, loss or damage arising from work performed after reading this guide, to the maximum extent permitted by law. If in doubt, use a qualified technician.